The rules and/or specifications set forth herein are designed to provide for the orderly conduct of racing events and to establish minimum acceptable requirements for such events. By making an application for a competitor permit, it is deemed that the competitor agrees to become familiar with these regulations and abide by the directions set forth and prescribed by Management. No express or implied warranty of safety shall result from publications of, or compliance with these rules and/or specifications. They are intended as a guide for the conduct of the sport and are in no way a guarantee against injury or death to participants, spectators, or others.


These vehicles are intended to be Fun, Fast, and Inexpensive to build and race.  


Any Stock OEM front-wheel drive, hardtop car, or Mini Van with a V6 engine.

Allowed models include GM, Ford, Chrysler, Mazda, Kia, Nissan. 

No limited edition, sports, or other high-performance models including turbo or superchargers.

VIN must be in place and easily readable. Must have a working ODB / ODB II system if so equipped.  

Stock for the make model and year of the vehicle except may have a 6-inch high rear spoiler along the trunk line and extend no further than the edge of the trunk cover.

The driver door should be reinforced with a horizontal steel plate no smaller than 3/8 inch thick by 12 inches in height and extending to no more than 6 inches past the driver's door in either direction. The plate must be solidly welded to the car or bolted to the door framework.

May have a front air dam no closer to the ground than 3” at the lowest point when full of fuel and with the driver in the car. Air Dam may run from the front wheel well to the front wheel well.

May have a 5-inch high spoiler across the rear deck (trunk) of the car.  The spoiler may not extend past the edge of the trunk.

The lowest point on the chassis/unibody may be no less than 6 inches from the ground (except front air dam), including side skirts with driver in the car.

All glass except windshield must be removed. Doors must be securely welded, bolted, or tied shut.

Fireproof 100 % cotton clothing or coveralls recommended.

Metal patches must be of a Minimum 22 gauge tin (no other materials allowed).

All 4 brakes must work.

The battery may be moved to the right front firewall but must remain under the hood.

Hood and trunk latches must be removed and replaced with quick release hood pins for hood and trunk. Hood and trunk must remain hinged with original hinges.

Any tire on a maximum 8 inch wide (bead set to bead set) stock steel wheels for the make and model of vehicle.  Must use 1-inch lug nuts.  Tire Tread Wear Rating of no less than 250. Tire information must be clearly legible or the tire will be disallowed. The Center of wheels may be reinforced.

The helmet must be either DOT or SNELL certified.

Gas tank must be ahead of the rear wheels and in its stock position under the vehicle.

Rear and passenger seats should be removed along with all other flammable materials.

Stock Dash must remain.

Rearview mirror allowed, centered to the windshield. All other mirrors must be removed.

No additional weights may be added.

          Contact Us




+1 (506) 388-2415



1157 Route 133

Grand-Barachois, New Brunswick

E4P 8C5

© 2020 by Thunder Mountain Entertainment.