The rules and/or specifications set forth herein are designed to provide for the orderly conduct of racing events and to establish minimum acceptable requirements for such events. By making an application for a competitor permit, it is deemed that the competitor agrees to become familiar with these regulations and abide by the directions set forth and prescribed by Management. No express or implied warranty of safety shall result from publications of, or compliance with these rules and/or specifications. They are intended as a guide for the conduct of the sport and are in no way a guarantee against injury or death to participants, spectators, or others.
NOTE: IF IT DOESN’T SAY YOU CAN DO IT, ASK THE TECH DIRECTOR FIRST.
This is the entry-level racing division. These vehicles are intended to be Fun, Fast, and Inexpensive. All vehicles should be “stock” to year, make and model with no modifications unless as stated below.
Any 4, 6, or 8 Cylinder hardtop car or 4 Cyl 1/4 Ton or 4 or 6 Cyl Front-wheel drive Mini Van.
No sports cars. No turbo-charged or all-wheel drives.
Must be 100% STRICTLY STOCK. Hood may be pinned and Battery may be moved to the firewall under the engine bonnet.
Steel drivers door plate a minimum of 1/4 inch thick is recommended. The plate may not extend more than 6 inches past the driver door (in front or back).
All doors must be welded, chained, bolted, or securely tied shut.
All glass must be removed, except the front windshield. Rear window may also remain in cars or 1/4 Tons.
Glass or other materials must not be removed at the Centre. Build it before you come. No broken glass allowed in the car.
Minimum 3 points seat belt required.
Rear and passenger seats must be removed.
Door panels may be removed. Dash must be unaltered.
The driver door must be welded, chained, or tied shut. If the driver's door comes open during your race you are disqualified for the race.
The driver door should be reinforced with plate steel. The plate should be a minimum 3/8 inch thick and 12 inches in height and extend no more than 6 inches past the driver's door (front and rear). The plate should be welded or bolted into the frame of the car.
The bumper may be chained to the frame of the car.
DOT 70 Series Tires only. Minimum treadwear rating of 250. Traction rating of no more than single A. No studded tires or "Single-Use" tires. Ie. Mud or Snow Tires however a Mud AND Snow tire is allowed.
Minimum DOT approved Helmet required. Snell Recommended.
Cotton shirt and pants or coveralls required.
Numbers will be assigned upon registration. Must be painted on at least 24 inches high on both doors and roof
Pre-race tech inspection required. Cars may be handicapped at Tech's discretion.